ISO INTERNATIONAL STANDARD 8318 Second edition 2000-03-01 Packaging Complete, filled transport packages and unit loads Sinusoidal vibration tests using a variable frequency Emballages Emballages d'expeédition complets et pleins et charges unitaires - Essais de vibration sinusoidale a fréquence variable Reference number ISO 8318:2000(E) ISO @ ISO 2000 ISO 8318:2000(E) PDFdisclaimer This PDF file may contain embedded typefaces. In accordance with Adobe's licensing policy, this file may be printed or viewed but shall not be edited unless the typefaces which are embedded are licensed to and installed on the computer performing the editing. In downloading this file, parties accept therein the responsibility of not infringing Adobe's licensing policy. The ISO Central Secretariat accepts no liability in this area. Adobe is a trademark of Adobe Systems Incorporated. Details of the software products used to create this PDF file can be found in the General Info relative to the file; the PDF-creation parameters were optimized for printing. Every care has been taken to ensure that the file is suitable for use by IsO member bodies. In the unlikely event ISO2000 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized in any form or by any means, electronic or mechanical, including photocopying and microfilm, without permission in writing from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 . CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 734 10 79 E-mail [email protected] Web www.iso.ch Printed in Switzerland ii @ISO 2000 -All rights reserved ISO 8318:2000(E) Foreword IsO (the International Organization for Standardization) is a worldwide federation of national standards bodies (isO member bodies). The work of preparing International Standards is normally carried out through IsO technical liaison with ISO, also take part in the work. ISO collaborates closely with the International Electrotechnical Commission(lEC)onallmattersofelectrotechnicalstandardization. Draft International Standards adopted by the technical committees are circulated to the member bodies for voting Publication as an International Standard requires approval by at least 75 % of the member bodies casting a vote. patent rights. IsO shall not be held responsible for identifying any or all such patent rights. International Standard ISO 8318 was prepared by Technical Committee ISO/TC 122, Packaging, Subcommittee ISO/TC122), This second edition cancels and replaces the first edition (IsO 8318:1986) which has been technically revised. @ISO 2000-All rights reserved ii