ISO INTERNATIONAL STANDARD 13041-5 Second edition 2015-03-15 Test conditions for numerically controlled turning machines and turning centres Part 5: Accuracy of speeds and interpolations Conditions d'essai des tours a commande numerique et des centres de tournage Partie 5: Exactitude des vitesses et interpolations Reference number IS0 13041-5:2015(E) ISO International Organization for Standardization @ IS0 2015 ed without license from IHS IS0 13041-5:2015(E) COPYRIGHTPROTECTED DOCUMENT @ISO2015 All rights reserved. Unless otherwise specified, no part of this publication may be reproduced or utilized otherwise in any form written permission. Permission can be requested from either ISO at the address below or ISO's member body in the country of the requester. ISO copyright office Case postale 56 : CH-1211 Geneva 20 Tel. + 41 22 749 01 11 Fax + 41 22 749 09 47 E-mail [email protected] Web www.iso.org Published in Switzerland Inteationai br DrganizationforStandardization No reproduction or networking permited without license from IHS Not for Resale, 2015/6/2 06:42:3 IS0 13041-5:2015(E) Contents Page Foreword ..iv Introduction. ..V 1 Scope. ..1 2 Normative references ..1 3 Terms and definitions 4 Preliminary remarks .3 4.1 Measurement units. .3 4.2 Reference to IS0 230-1 and IS0 230-4 .3 4.3 Testing sequence.. .4 4.4 Tests to be performed .4 4.5 Measuring instruments 4 4.6 Software compensation .4 5 Tests described in Annexes A to C .4 Annex A (normative) Kinematic tests for machines with a horizontal workholding spindle. ..5 Annex B (normative) Kinematic tests for machines with a vertical workholding spindle ..13 Annex C (normative) Kinematic tests for machines with inverted vertical workholding spindles.21 Annex D (informative) Precautions for test setup for AK6, BK6, and CK6 .29 Bibliography .33 ii nsee=Zhejiang Institute of Standardization 5956617 thout license from IHS