论文标题
测量热力学成本计时成本
Measuring the thermodynamic cost of timekeeping
论文作者
论文摘要
所有时钟以某种形式或另一种形式都使用自然的演变向更高的熵状态量化时间来量化时间的流逝。由于第二定律的统计性质和相应的熵流,因此从根本上限制了任何时钟的性能。这表明熵的增加与时钟滴答的质量之间存在很深的关系。实际上,量子领域中自动钟的最小模型表明,可以得出线性关系,对于有限的制度,每一位熵都可以线性地提高量子时钟的准确性。但是,当我们朝着更古典的系统迈进时,这种线性关系可以持续存在吗?我们通过在纳米级时钟中对这种热力学关系进行首次实验研究来回答这一点。我们随机地驾驶纳米厚的膜,并用射频腔读取其位移,从而使我们能够识别时钟的壁虱。从理论上讲,我们表明该经典时钟的最大可能准确性与每滴答的熵成正比,类似于弱耦合量子时钟的已知限制,但比例性不变。我们测量精度和熵。一旦考虑到非热噪声,我们发现准确性和熵之间存在线性关系,并且时钟在理论结合的数量级内运行。
All clocks, in some form or another, use the evolution of nature towards higher entropy states to quantify the passage of time. Due to the statistical nature of the second law and corresponding entropy flows, fluctuations fundamentally limit the performance of any clock. This suggests a deep relation between the increase in entropy and the quality of clock ticks. Indeed, minimal models for autonomous clocks in the quantum realm revealed that a linear relation can be derived, where for a limited regime every bit of entropy linearly increases the accuracy of quantum clocks. But can such a linear relation persist as we move towards a more classical system? We answer this in the affirmative by presenting the first experimental investigation of this thermodynamic relation in a nanoscale clock. We stochastically drive a nanometer-thick membrane and read out its displacement with a radio-frequency cavity, allowing us to identify the ticks of a clock. We show theoretically that the maximum possible accuracy for this classical clock is proportional to the entropy created per tick, similar to the known limit for a weakly coupled quantum clock but with a different proportionality constant. We measure both the accuracy and the entropy. Once non-thermal noise is accounted for, we find that there is a linear relation between accuracy and entropy and that the clock operates within an order of magnitude of the theoretical bound.